Light-induced degradation in amorphous silicon thin film solar cells

In the initial state (left), the voids' internal surfaces are saturated with hydrogen atoms so that no defects are observed. Light-induced charge carriers (h<sup>+</sup>) destabilize atomic bonds. The breaking of atomic bonds causes defects (indicated by the vertical arrows on the right hand side), which translates to reduced solar cell efficiency.

In the initial state (left), the voids' internal surfaces are saturated with hydrogen atoms so that no defects are observed. Light-induced charge carriers (h+) destabilize atomic bonds. The breaking of atomic bonds causes defects (indicated by the vertical arrows on the right hand side), which translates to reduced solar cell efficiency. © HZB

Researchers at the Helmholtz Center Berlin (HZB) have taken a leap forward towards a deeper understanding of an undesired effect in thin film solar cells based on amorphous silicon – one that has puzzled the scientific community for the last 40 years. The researchers were able to demonstrate that tiny voids within the silicon network are partly responsible for reducing solar cell efficiency by some 10 to 15 percent as soon as you start using them. Their work has now been published in Physical Review Letters (DOI: 10.1103/PhysRevLett.112.066403).

Amorphous silicon thin film solar cells are considered a promising alternative to solar cells based on highly purified silicon wafers, which have been dominating photovoltaic power generation. A major advantage of amorphous silicon thin film photovoltaics, where a glass substrate is coated with a light active material less than a thousandth of a millimeter thick, is that the cell fabrication is considerably simpler and much less costly than in the case of conventional crystalline silicon solar cells. On the other hand, a potential disadvantage is the low conversion efficiency from solar energy to electricity. Because of the disordered nature of amorphous silicon, solar cells are subject to the Staebler-Wronski effect, which reduces the solar cell efficiency by up to 15 percent within the first 1000 hours.

This undesired effect is triggered by internal annihilation – known in physics as recombination - of charge that has not been extracted from the solar cell. The released recombination energy induces defects in the amorphous network - which is why this effect is not observed in crystalline wafer solar cells. "However, where defects are produced in the material and whether voids of nanoscale size play a role in all this has not been understood – until now, that is," says HZB’s own Matthias Fehr of the Institute for Silicon Photovoltaics. Fehr together with his HZB colleagues, scientists from Jülich Research Center and the Free University of Berlin have now made major strides towards unraveling this mystery.

Since the defects that form exhibit paramagnetic properties, they have a characteristic magnetic fingerprint, which depends on their microscopic environment. The Berlin researchers were able to identify this fingerprint using electron-paramagnetic resonance (EPR) spectroscopy and electron-spin echo (ESE) experiments. With the help of these highly sensitive techniques, they determined  that defects in amorphous silicon actually come in two types: those that are uniformly distributed and those that are concentrated in clusters on internal surfaces of small voids - known in scientific circles as microvoids - which form within the material during the solar cell manufacturing process. "Our guess is that clusters of defects are generated on the internal walls of microvoids, which have a diameter of a mere one to two nanometers," explains HZB physicist Fehr.
"Our findings seem to suggest that microvoids most likely contribute to light-induced degradation of amorphous silicon thin film solar cells. For us, it’s been a leap forward towards a better understanding of the microscopic mechanism of light-induced degradation," says Fehr who, in 2013, spent a year conducting research in the US as a Feodor Lynen Scholar of the Alexander Humboldt Foundation. A new series of experiments has been designed to allow the Berlin researchers to glean further insights into the atomic and electronic processes of the Staebler-Wronski effect, named for the two scientists who first discovered it.

The work is part of the EPR-Solar network funded by the German Federal Ministry for Education and Research and the HZB's and FUB's Berlin Joint EPR Lab. According to the head of the project, Prof. Dr. Klaus Lips, "this is one of the major projects of one of the HZB's newest research departments, which is currently in the founding stage and whose mission is the fundamental  physical characterization of energy materials with the goal of making an important contribution to the energy transition."

References:
[1] Fehr, M., Schnegg, A., Rech, B., Astakhov, O., Finger, F., Bittl, R., Teutloff, C., Lips, K. (2014) Metastable defect formation at microvoids identified as a source of light-induced degradation in a-Si:H. Phys. Rev. Lett. (accepted)

Autor: Ralf Butscher

  • Copy link

You might also be interested in

  • Cool vaccines in rural Kenya: solar solution has been awarded by UN
    Interview
    11.05.2026
    Cool vaccines in rural Kenya: solar solution has been awarded by UN
    In May 2026, Tabitha Awuor Amollo is spending some weeks as a guest scientist at HZB, analysing perovskite thin films at BESSY II. The Kenyan physicist from Egerton University, Nairobi, was recently recognised for her achievements in research and teaching. For the development of a solar-powered refrigeration system for use in rural health centres, she  has been awarded the 2026 Organization for Women in Science for the Developing World (OWSD)-Elsevier Foundation Award. An interview on exceptional projects and daily struggles of a scientist. Questions were asked by Antonia Rötger.
  • BESSY II: How intrinsic oxygen shortens the lifespan of solid-state batteries
    Science Highlight
    08.05.2026
    BESSY II: How intrinsic oxygen shortens the lifespan of solid-state batteries
    Although solid-state batteries (SSBs) demonstrate high performance and are intrinsically safe, their capacity currently declines rapidly. A team from the TU Wien, Humboldt-University Berlin and HZB has now analysed a TiS₂|Li₃YCl₆ solid-state half-cell in operando at BESSY II using a special sample environment that allows for non-destructive investigation under real operating conditions. Data obtained by combination of soft and hard X-ray photoelectron spectroscopy (XPS and HAXPES) revealed a new degradation mechanism that had not previously been identified in solid-state batteries. They have gained some surprising insights, particularly regarding the harmful role played by intrinsic oxygen. This study provides valuable information for improving design and handling of such batteries.
  • Electrocatalysts: New model for charge separation at the solid-liquid interface
    Science Highlight
    16.04.2026
    Electrocatalysts: New model for charge separation at the solid-liquid interface
    Hydrogen is at the heart of the transition to carbon neutrality, as both an energy carrier and a reagent for green chemistry. However, large-scale production of hydrogen via electrolysis, as well as the production of many other chemical products, requires significantly cheaper and more efficient catalysts. A precise understanding of the electrochemical processes that take place at the interface between the solid catalyst and the liquid medium is highly useful for developing better electrocatalysts. In the journal Nature Communications, an European team has now presented a powerful model that determines charge separation at the interface, the formation of the electric double layer and local electric potential variations, and the resulting influence on the catalytic activity.