BESSY II: How intrinsic oxygen shortens the lifespan of solid-state batteries
A view of the operando cell in the sample chamber during the measurements at the SISSY Endstation. © E. Kataev/HZB
Left: A schematic of the operando battery half-cell that was examined. Right: An illustration of the formation of an oxygen-rich amorphous layer during cycling. © ACS Energy Lett. 2026, 11, 5, 4018-4025
Although solid-state batteries (SSBs) demonstrate high performance and are intrinsically safe, their capacity currently declines rapidly. A team from the TU Wien, Humboldt-University Berlin and HZB has now analysed a TiS₂|Li₃YCl₆ solid-state half-cell in operando at BESSY II using a special sample environment that allows for non-destructive investigation under real operating conditions. Data obtained by combination of soft and hard X-ray photoelectron spectroscopy (XPS and HAXPES) revealed a new degradation mechanism that had not previously been identified in solid-state batteries. They have gained some surprising insights, particularly regarding the harmful role played by intrinsic oxygen. This study provides valuable information for improving design and handling of such batteries.
Solid-state batteries (SSBs) offer several advantages over conventional batteries, including higher energy and power densities, as well as greater safety, as they do not contain flammable liquid electrolytes. However, since lithium ions migrate between the working electrode and the counter-electrode during operation, the solid material can suffer by volume changes, which can lead to cracks. In order to maintain contact between electrodes and electrolyte, SSBs must be operated under high pressure. Volume changes, as well as degradation processes at the interfaces, often limit the lifespan of these batteries. Until now, it has been virtually impossible to observe these processes experimentally, particularly due to the high stacking pressure required during operation. However, Dr Elmar Kataev, a scientist at HZB, has now developed a sample environment that enables operando analysis of SSBs under high pressure using two-colour – soft and hard – X-ray photoelectron spectroscopy (XPS and HAXPES) at the SISSY endstation at BESSY II. These conditions of combining two different energies of X-rays (hard for bulk sensitivity and soft – for surface) hitting the same spot is exclusively available at EMIL beamline.
In collaboration with Dr Katherine Mazzio of the TU Wien, the team has now, for the first time, been able to distinguish between reactions at the surface and at buried interfaces, and analyse the degradation mechanisms of TiS2|Li3YCl6 half-cells in greater detail. ‘We have gained some surprising insights, particularly regarding the harmful role played by intrinsic oxygen. We observed that during cycling oxygen-containing species migrate towards the cathode current collector, where they react with the active electrode material near the current collector interface. This results in the formation of an amorphous layer rich in titanium oxides. This is a major cause of the rapid loss of capacity,’ says Mazzio.
These findings are extremely important for the further development of SSBs. This is because the ingress of oxygen into the battery cells should be reduced or even prevented during production of the constituent materials, prioritizing its manufacturing in under an inert gas atmosphere.
- Cool vaccines in rural Kenya: solar solution has been awarded by UNIn May 2026, Tabitha Awuor Amollo is spending some weeks as a guest scientist at HZB, analysing perovskite thin films at BESSY II. The Kenyan physicist from Egerton University, Nairobi, was recently recognised for her achievements in research and teaching. For the development of a solar-powered refrigeration system for use in rural health centres, she has been awarded the 2026 Organization for Women in Science for the Developing World (OWSD)-Elsevier Foundation Award. An interview on exceptional projects and daily struggles of a scientist. Questions were asked by Antonia Rötger.
- Spintronics at BESSY II: Real-time analysis of magnetic bilayer systemsSpintronic devices enable data processing with significantly lower energy consumption. They are based on the interaction between ferromagnetic and antiferromagnetic layers. Now, a team from Freie Universität Berlin, HZB and Uppsala University has succeeded in tracking, for each layer separately, how the magnetic order changes after a short laser pulse has excited the system. They were also able to identify the main cause of the loss of antiferromagnetic order in the oxide layer: the excitation is transported from the hot electrons in the ferromagnetic metal to the spins in the antiferromagnet.
- Electrocatalysts: New model for charge separation at the solid-liquid interfaceHydrogen is at the heart of the transition to carbon neutrality, as both an energy carrier and a reagent for green chemistry. However, large-scale production of hydrogen via electrolysis, as well as the production of many other chemical products, requires significantly cheaper and more efficient catalysts. A precise understanding of the electrochemical processes that take place at the interface between the solid catalyst and the liquid medium is highly useful for developing better electrocatalysts. In the journal Nature Communications, an European team has now presented a powerful model that determines charge separation at the interface, the formation of the electric double layer and local electric potential variations, and the resulting influence on the catalytic activity.