Photochemical Turbo Power for Solar Cells

Red light from a laser pointer is converted into higher-energy yellow<br />light as it passes through the liquid photochemical upconverter.<br />Source: University of Sydney, Australia

Red light from a laser pointer is converted into higher-energy yellow
light as it passes through the liquid photochemical upconverter.
Source: University of Sydney, Australia

How organic molecules make yellow light from red.

They have developed a kind of “turbo for solar cells”, called photochemical upconversion: Two energy-poor photons that would normally be ineffective in the solar cell are merged into one energy-rich photon, which can then contribute towards the electricity yield. Further research in this direction may make it possible to exceed the 30 percent mark. The team has published its results in the journal “Energy & Environmental Science” (DOI: 10.1039/C2EE21136J).

The photochemical solar-cell turbo uses organic molecules to merge energy-poor red photons together into energy-richer yellow photons. The secret is in the choice of molecules, of which two different types are placed behind the solar cell in solution. The task of the first molecule type is to absorb the energy-poor light particles and to store their energy. The crux here is that these molecules enter a persistent state in which the spins, or magnetic moments, of the light-excited electrons in each molecule line up in parallel. This prevents re-emission of the absorbed particles.

This persistent state of the first molecule type lasts long enough for the energy to be transferred into a persistent state of a second type of organic molecule. This energy transfer takes place when the two types of molecule encounter each other in the solution. If two excited molecules of the second type then encounter each other, then one of them returns to its base state. The other thereupon assumes an even higher energy state, which is extremely short-lived. This latter molecule then sends off a single photon of high enough energy to be absorbed by the solar cell.

“We are thus the first to demonstrate an efficiency gain in a solar cell by photochemical upconversion,” says project head Dr. Klaus Lips of the HZB Institute for Silicon Photovoltaics. “The achieved increase in solar cell efficiency is still low – about 0.1 percent absolute – and the sunlight even had to be concentrated fifty times, but the path to further improvement is clearly discernible.” Yet it is rocky and hard, as Lips emphasizes: “For the concept study now published, we had not used a 25 percent high-capacity solar cell yet, as will be needed for later practical application.” They now have to redevelop the organic molecules of the photochemical upconverter so that they do not have to be dissolved in a liquid. They will also have to perform their action under normal, unconcentrated sunlight, and an infrared converter will be required for crystalline silicon.

“The concepts for this were developed in close cooperation between Sydney and HZB,” says Klaus Lips. The essential advantage of this ‘3rd generation photovoltaics’ over other approaches is there is no need for costly redevelopment of solar cells; rather, merely adding the upconverter would in principle suffice to boost the efficiency. Klaus Lips concludes: “Just as you would build a turbo into a car to make it go faster – and wouldn’t necessarily go and design an entirely new car.”

Further Information:

Timothy Schmidt
School of Chemistry
University of Sydney, Australia
Tel.: +61 (439) 386109
t.schmidt@chem.usyd.edu.au

HS

  • Copy link

You might also be interested in

  • Nanosilver as an electrocatalyst for CO&#8322; reduction
    Science Highlight
    24.09.2026
    Nanosilver as an electrocatalyst for CO₂ reduction
    Via electrolysis, CO2 can be reduced to CO, a raw material for further chemical products such as fuels. Within the GreenQuest Project, an internation team led by HZB chemist Prashanth Menezes has now systematically investigated catalyst layers made of silver nanoparticles, varying both the size of the particles and their density. The best yield was achieved with nanoparticles with diameters of around 10 nm, which were loosely distributed. Furthermore, they demonstrated how the economic efficiency of the electrochemical cell can be enhanced by integrating an additional chemical reaction at the anode, enabling the simultaneous production of a valuable formic acid, hydrogen, and CO in one device.
  • Spin waves inside a nano-oscillator imaged for the first time
    Science Highlight
    23.09.2026
    Spin waves inside a nano-oscillator imaged for the first time
    For the first time, researchers have directly imaged the magnetisation dynamics inside a spin Hall nano-oscillator — a nanoscale device that converts direct current into tunable microwave signals and is a promising building block for energy-efficient wireless communication and brain-inspired computing. A Swedish–German team led by the University of Gothenburg and Helmholtz-Zentrum Berlin (HZB) achieved this using time-resolved scanning transmission X-ray microscopy at the MAXYMUS instrument at BESSY II. The results, now published in Advanced Materials, reveal spin-wave features that had escaped previous, indirect measurement techniques.
  • Marcel Risch has been appointed Professor at the Freie Universität Berlin
    News
    17.09.2026
    Marcel Risch has been appointed Professor at the Freie Universität Berlin
    Marcel Risch was appointed to a W2-S professorship in the Department of Physics at Freie Universität Berlin in August 2026. His research group has been transformed into the department 'Mechanisms of Sustainable Electrocatalysis'. Risch investigates the fundamental mechanisms of electrocatalytic reactions and, on this basis, develops knowledge- and data-driven strategies to improve electrocatalysts for the sustainable production of hydrogen, fuels and chemicals.