Perovskite solar cells: Defects trap charge carriers - and release them again
Five different types of defects in MAPI-perovskites were examined and characterised. The result: a large proportion of defects is not trapping the charge carriers for long. © HZB
An international team at HZB and Charles University Prague has investigated how charge carriers in so called MAPI-perovskite semiconductors interact with different defects. They show that a large proportion of defects quickly releases trapped charge carriers. These results could help to further improve the properties of perovskite solar cells.
Among the most exciting materials for solar cells are the so-called MAPI semiconductors. They consist of organic methylammonium cations and lead iodide octahedra that form a perovskite structure. MAPI based solar cells have achieved efficiencies of 25 % within a few years. But so far, the semi-organic semiconductors are still ageing rapidly.
Now, for the first time, physicists at HZB, CNRS, France and Charles University, Prague, Czech Republik, have precisely characterised five different defect types and measured the interaction between these defects and the charge carriers.
Using a combination of highly sensitive spectroscopy methods, they succeeded in experimentally determining the concentration, energy, capture cross-section and charge capture time of the different defects and creating a map of the defects. By using electric pulses, they made sure that the measurements did not affect the quality of the material.
The measurement results allow the reliable differentiation between electron and hole transport and the determination of their most important parameters: Mobilities, lifetimes and diffusion lengths. "This work thus provides answers to questions that have been discussed for a long time in the field of perovskite solar cells," says Dr. Artem Musiienko, first author of the publication and postdoc at HZB.
An important finding: a large proportion of the defects release the captured charge carriers again after a short time. "This may partly explain these particularly high efficiencies of the MAPI perovskites," says Musiienko. These results pave the way to optimise MAPI perovskites in terms of defect concentration, combining high efficiencies with good stability.
- A new way to control the magnetic properties of rare earth elementsThe special properties of rare earth magnetic materials are due to the electrons in the 4f shell. Until now, the magnetic properties of 4f electrons were considered almost impossible to control. Now, a team from HZB, Freie Universität Berlin and other institutions has shown for the first time that laser pulses can influence 4f electrons- and thus change their magnetic properties. The discovery, which was made through experiments at EuXFEL and FLASH, opens up a new way to data storage with rare earth elements.
- BESSY II shows how solid-state batteries degradeSolid-state batteries have several advantages: they can store more energy and are safer than batteries with liquid electrolytes. However, they do not last as long and their capacity decreases with each charge cycle. But it doesn't have to stay that way: Researchers are already on the trail of the causes. In the journal ACS Energy Letters, a team from HZB and Justus-Liebig-Universität, Giessen, presents a new method for precisely monitoring electrochemical reactions during the operation of a solid-state battery using photoelectron spectroscopy at BESSY II. The results help to improve battery materials and design.
- From waste to value: The right electrolytes can enhance glycerol oxidationWhen biomass is converted into biodiesel, huge amounts of glycerol are produced as a by-product. So far, however, this by-product has been little utilised, even though it could be processed into more valuable chemicals through oxidation in photoelectrochemical reactors. The reason for this: low efficiency and selectivity. A team led by Dr Marco Favaro from the Institute for Solar Fuels at HZB has now investigated the influence of electrolytes on the efficiency of the glycerol oxidation reaction. The results can help to develop more efficient and environmentally friendly production processes.