Akrivos, V.; Wimpory, R.C.; Hofmann, M.; Stewart, B.; Muransky, O.; Smith, M.C.; Bouchard, J.: Neutron diffraction measurements of weld residual stresses in three-pass slot weld (Alloy 600/82) and assessment of the measurement uncertainty. Journal of Applied Crystallography 53 (2020), p. 1181-1194
Open Accesn Version
This paper describes in detail two neutron diffraction residual stress measurements, performed on the ENGIN-X neutron scattering instrument at the ISIS facility in the UK and on the SALSA instrument at the Institut Laue–Langevin in Grenoble, France. The measurements were conducted as part of the NeT Task Group 6 (TG6) international measurement round robin on an Alloy 600/82 multi-pass weldment – a slot in an Alloy 600 plate filled with three Alloy 82 weld beads, simulating a repair weld. This alloy/weld combination is considered challenging to measure, due to the large grain size and texture in the weld, and large gradients in the stress-free lattice parameter between the parent and weld metal. The basic principles of the neutron diffraction technique are introduced and issues affecting the reliability of residual stress characterization are highlighted. Two different analysis strategies are used for estimation of residual stresses from the raw data. Chemical composition studies are used to measure the mixing of parent and weld metal and highlight the steep lattice parameter gradients that arise as a consequence. The inferred residual stresses are then compared with three sets of measurements performed on the same plate by other NeT partners on E3 at the HZB in Berlin, STRESS-SPEC at the FRM II in Munich and KOWARI in Sydney. A robust Bayesian estimation average is calculated from the combined five-instrument data set, allowing reliable best estimates of the residual stress distribution in the vicinity of the weldment. The systematic uncertainties associated with the residual stress measurements are determined separately in the weld and parent materials, and compared with those in the NeT TG4 benchmark. This is a three-pass slot-welded plate fabricated from American Iron and Steel Institute AISI 316L(N) austenitic stainless steel, and is normally considered less challenging to measure using diffraction techniques than all nickel welds. The uncertainties in the stress measurements by neutron diffraction for these two weldments seem to be comparable.